The benefits of ecological filtration for swimming pools

System adaptable to all pool sizes

From the small 3 x 5 family pool to the 14 x 7 pool, the system is infinitely modular!

You just have to respect the rule: 1 filter module per 25 m3

 

Swimming pool without technical room

The filter module(s) being very compact , they are installed directly in the backfill of the pool during its construction and are completely invisible (except for the access hatch on the surface)

It is therefore not necessary to have a technical room.

 

Water circulation respected

Unlike existing filtration blocks which combine a skimmer and a discharge in the same area, our system respects the classic circulation which promotes better mixing of the water in the pool: Suction from the bottom and from the surface with 1 (or more) skimmer(s) and discharges on the opposite side.

 

Absolute silence in operation

No more of the often very annoying hum of traditional pumps, our swimming pool filtration system makes absolutely no noise   because the pump is submerged in 30cm of water and located in a buried tank, closed with a watertight cover.

 

Power consumption 5 to 6 times lower than traditional filtration

The pump that equips our modules consumes only 50 W/h for an actual flow rate of 7 m3/h.

 

This technological miracle is possible thanks to the design of its latest generation digital motor, but also to the position of the pump (located at the same height as the discharges) and especially to the principle of "communicating vessels" which means that the water arrives by gravity through the filters and into the pump without the latter needing to suck up the water column and thus conserve energy.

 

Optionally, the filtration can be powered by a 150wc solar panel which will fully cover the consumption of 2 modules. In periods of low use of your filtration, our "intelligent" solar system will automatically send the unused surplus to your home and can be used by your various electrical devices.

 

More efficient filtration than a sand filter

Each filter module is equipped with 2 filters. A first, with a filtration fineness of approximately 50 microns intended to collect the largest impurities (twigs, insects, etc.) and a second filter of very high capacity made up of a reinforced synthetic media, with a fineness of 15 microns and a total surface area of 16.3 m².

 

The pump flow rate / filter surface ratio provides a very slow passage through the filter media

(0.37 m3 / h / m²), guaranteeing incomparable water quality (for information, a sand filter has a fineness of 40 microns and a rapid passage of approximately 40 m3 / h / m²)

This very slow passage of water also helps to preserve the filter and therefore

Space out periodic interviews

 

Water saving

As we have just seen, cleaning our filter media is done less often than a sand (or diatomaceous earth) filter, the operation simply consists of brushing it under a tap. There is therefore practically no water consumption for its maintenance.

For information: A sand filter consumes on average 750 liters of water per wash! Knowing that this wash must be carried out every 15 days, do the math!

 

Installation cost identical to traditional filtration

The installation of filter modules requires much less work than conventional filtration.

The gain in pipes, fittings, valves and especially MO compensates for the value of 2 filter modules.

(without taking into account any possible cost of creating a technical room)